Emergency and Exit Lighting

Provides emergency lighting maintenance services. There are the following steps.

1. If an emergency lamp was purchased, reinstalled. Set around to maintain the distance according to วสท. 2004-58 It is defined as follows.

3 month audit

Emergency lighting can be checked by inserting the battery into the lamp. To simulate failure of the power supply for a certain period to ensure that the lamp is working properly. The test period must not be less than 60 minutes during this period. To make sure it is working properly.

1 year audit

Emergency lighting can be checked by inserting the battery into the lamp. To simulate the failure of the power supply for a certain period to ensure that the lamp is working normally, the test period must be no less than 90 minutes during this time. To make sure it is working properly This test is a preliminary test of the work. Of the emergency lamp Depending on the test, time may be selected. To test Because if after the test and there is a blackout. Emergency lights can not. I have to re-charge.

*** Emergency lamp If you have purchased an emergency light bulb, do not connect the battery terminals before charging.

2. If applied for a while. The terminals connected to the battery may have a goose. Happened to do cleaning. By the maintenance cycle. May stay at every 6 months.

3. One important device is the light bulb. Typically, the bulbs used in assembly are LEDs and neon lights. Clean them with a clean cloth.

4. Unplug the power cord of the emergency light, the emergency light bulb connected to the appliance. Leave it for about 30 minutes or leave it until The Automatic Low Voltage Cut-Off System (UPS) automatically cuts off the power supply. After the test. Plug in the emergency power supply to the outlet as usual. To maintain battery life, if possible every month, the battery lasts 3-5 years.